Applying Vinyl Siding Starter Strip

This video shows how to install a starter strip for vinyl and polymer siding installation.

Applying vinyl siding starter strip.

Installing inside corner. Be sure to center the nails in their slots to. Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape. Mice bees and all sorts of other critters love making their home inside vinyl corner posts.

Determine the lowest point of the wall that will be sided. Vinyl siding starter strips. Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house. Pull up as.

Position starter strip with the top edge of chalk line and allow room for corner posts. Pull the zip tool down while simultaneously. Locate the lowest possible corner that has sheathing. Hold a tape measure against the exterior wall and travel.

Slide it into the corner and nail it every 16 in. Staret strip secures the first course of siding to the home. Cap the corner posts. From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner.

Insulation for vinyl siding 1. Find the lowest corner of the old siding or sheathing on the house. Attach j channel trim strips around windows and doors and along the eaves. Partly drive a nail 11 2 in.

In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level. How to install a vinyl siding starter strip step 1. Snap each length of siding in place so that its bottom lip hooks under the starter strip. Nail vertical vinyl corners to the corners of the house making sure they are plumb.

This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows. Pop a level chalk line for the starter strip an inch or two above the bottom of the siding. Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests on top of the starter strip. 13 simple vinyl siding installation tips use the wider starter strip.